Are there any implementations of this out there or is this purely theoretical (at this point in time)?
Are there any implementations of this out there or is this purely theoretical (at this point in time)?
* $400 / yr
It is, kind of. The plug is secured by 6 stops (or tabs) along each side. The positive pressure differential pushes the plug outwards into those stops.
To remove the plug you uninstall 4 bolts which allow the plug to go up and over the stops, after which it can hinge outwards on a hinge found at the bottom of the plug.
The main reason for splitting up the relays into two sets is that with 10A traces the connector pins would violate minimum separation distances. I would have to get even larger connectors. The ones in the design have 5 mm pitch.
I'm assuming the original board also did this for the same reason although their board is set up for 8 motors split into sets of 4.
I've also had some trouble sourcing a 10A fuse suited for inductive loads but I'm sure I could find one with some more time.
The whole board is on its own house circuit fused with a 16A breaker.
Seeing these little IT gems all over Lemmy always makes me smirk :)
I suspect that if you were to cut the screen at the rounded edges, the sensor island and the onscreen nav buttons you'll be left with a 16:9 screen.
In other words its a 16:9 screen with some margin for curves and controls.
Always mocking Dr. Daniel Jackson. Poor guy